Vimar Elvox 41006 Manuel Installateur page 16

41006
Indicators
The device has three LEDs dedicated specifically to the alerts and located at the top right, in addition to the four white LEDs,
already mentioned, located at the push buttons. Their appearance in the various situations of operation and use is described
below.
Local configuration
The white LEDs associated with the push buttons blink during local configuration tasks, with the timing described below
depending on the state of the device.
Status
Waiting for ordering push button modules 41010
The current value of the selected parameter (lock time, conversation time or
audio level) is not configurable via the push button interface (it was set using the
configuration software).
Standard operation
Status
Call in progress
Communication active
Lock activated
Missed communication (user busy or offline)
Video message recording in progress
Device start-up
Status
A - Switch-on
B – Detection of secondary modules and/or waiting for or-
dering modules art. 41010
C – Secondary module firmware updating in progress
D1 – Device awaiting configuration
D2 – Device configured but not operational
D3 – Device operational
Times: 0.25 s ON, 0.75 s OFF.
1
Times: 1.00 s ON, 0.75 s OFF.
2
C status is only achieved when there are secondary modules to update. D1, D2 and D3 statuses are alternative to each
other: the first two are reached only during system installation and configuration. The three possible switch-on sequences
are described below:
• First start-up: A, B, C (optional), D1. The device awaits configuration (via the stated software) and when obtained it is
restarted, running the next sequence.
16
All manuals and user guides at all-guides.com
L3
L2
L1
Icon
On - ON
LED
L3 blinking
L3 ON
L2 ON
L1 ON
L3 ON, L1 blinking
LED L3
ON
OFF
OFF Blinking
Blinking Blinking
1
Blinking Blinking
2
OFF
EN
LED Colour
L3 Green
L2 Green
L1 Red
Off - OFF
0.50 s 1.00 s
0.10 s 0.50 s
LED L2 LED L1
ON ON
OFF Blinking
Blinking
1
Blinking
1
Blinking
2
OFF OFF
1
1
1
2