Vimar Elvox 41006 Manuel Installateur page 14

41006
LED flashing and so on. If all the LEDs of a module blink,
then that module has not yet been ordered.
Now press any one push button per module, to indicate the
order of the modules. The push button at the top left of the
first module will take the number 5, the push button at top left
of the second module 15, and so on.
You have 10 s to complete this step. The time restarts with
each push button pressed. If you do not complete the task,
the configuration is not updated.
When the position of a module has been selected, a number
of LEDs equal to the chosen position will light up steady.
The procedure ends automatically after ordering the last
module. The LEDs are all lit up steady.
However you exit the procedure, the speech unit will emit a
warning tone.
2. Lock time
Through the procedure described here, the lock time can
only be set to the values of 1 s (default) and 5 s. With the
configuration software other values are possible from 0 (lock
totally disabled) to 30 s. If this has been done previously, all
4 LEDs will blink to alert you that you are changing a con-
figuration that then cannot be restored using the procedures
stated here.
LED configuration Meaning
1 second (default)
5 seconds
All 4 LEDs are flashing:
Different value to the above
With the (PREVIOUS) and
you can select the desired value.
Pressing (DEL) takes you back to the previous level,
without saving any changes.
Press (OK) to confirm what you have chosen.
3. Conversation time
Through the procedure described here, the talk time can
only be set to the values of 2 (default) and 5 minutes. With
the configuration software other values are possible from 10
to 300 s. If this has been done previously, all 4 LEDs will
blink to alert you that you are changing a configuration that
then cannot be restored using the procedures stated here.
LED configuration Meaning
2 minutes (default)
14
All manuals and user guides at all-guides.com
(NEXT) push buttons
With the (PREVIOUS) and
you can select the desired value.
Pressing (DEL) takes you back to the previous level,
without saving any changes.
Press (OK) to confirm what you have chosen.
4. Audio level
The audio level is configurable on 4 levels.
LED configuration
With the (PREVIOUS) and
you can select the desired value.
Pressing (DEL) takes you back to the previous level,
without saving any changes.
Press (OK) to confirm what you have chosen.
5. Restart
Pressing (OK) controls device restart.
EN
5 minutes
All 4 LEDs are flashing:
Different value to the above
(NEXT) push buttons
Meaning
25 %
50 % (default)
75 %
100 %
(NEXT) push buttons