Publicité
Les langues disponibles
Les langues disponibles
slots clean. Keep all working controls free of
dust. If you see some sparks flashing in the
ventilation slots, this is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
wARNING: when not in use,
slacken the guard arm clamp knob
(9) to make the pressure foot fully down
to the table (See Fig. P). This will prevent
injury from the saw blade.
To insure proper operation and extend tool
life, prevent dust from accumulating under the
table insert (13).
1. Be sure to use a vacuum or dust extractor
for dusty cutting operations such as
ceramic tile. (See Fig. Q)
2. If dust accumulates, remove the table insert
by lifting the latch (e). (See Fig. R)
3. Vacuum out the dust in and around the
blade holder. (See Fig. S)
4. Reattach the table insert securely.
ENVIrONMENTAL
PrOTECTION
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means
that this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
european Directive 2002/96/Ce. It will then
be recycled or dismantled in order to reduce
the impact on the environment. electric and
electronic equipment can be hazardous for the
environment and for human health since they
contain hazardous substances.
Multi-function saw
All manuals and user guides at all-guides.com
PLUG rEPLACEMENT (UK &
IrELAND ONLY)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows. The wire which
is coloured
blue must be connected to the terminal which
is marked with N. The wire which is coloured
brown must be connected to the terminal
which is marked with L.
plug. only fit an approved BS1363/A plug and
the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
wARNING: Never connect live or
neutral wires to the earth terminal of the
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
15
EN
Publicité
