Publicité
Step 12
å
Separate the EXTENSION SLIDES (40NC) from the EXTENSION RAILS (40NA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (40NA) to the RIGHT END (A) and RIGHT UPRIGHT (D). Use four GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the SMALL DRAWER and PENCIL DRAWER.
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Open end
www.sauder.com/service
40NC
4
3
2
1
D
2
3
4
A
421934
40NA
Open end
1
7
Page 17
Publicité
