Publicité
Step 13
å
Fasten the EXTENSION BLOCKS (T) to the UPRIGHTS (D and E). Use four BLACK 1-1/4" FLAT HEAD SCREWS (7S).
å
Fasten the remaining two EXTENSION RAILS (40NA) to the EXTENSION BLOCKS (T). Use four GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the EXTENSION BLOCK. Turn a
SCREW into this hole.
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
3
2
Open end
1
T
Page 18
4
Surface with
more holes
Unfinished
strip
4
7S
E
Open end
1
2
3
T
D
421934
7
7S
BLACK 1-1/4" FLAT HEAD SCREW
(4 used for the EXTENSION BLOCKS)
The large hole
must be here.
www.sauder.com/service
Publicité
