Publicité
Step 5
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the
BACKS (F and N) until the shoulders of the SCREWS rest on
the surfaces of the BACKS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the BACK MOLDINGS (K and Q) onto the BACKS (F
and N). Line up the grooves in the MOLDINGS over the
heads of the SCREWS in the BACKS.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
å
NOTE: The MOLDINGS should be centered
on the BACKS.
Page 10
F
Q
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
N
K
Shoulder
421934
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/service
32S
Publicité
