HURAKAN IP10F Mode D'emploi page 16

Overall dimensions
A B
mm
IP10F 500 470
IP20F 570 570
IP30F 800 670
IP40F 800 670
IP60F 1240 980
IP80F 1240 980
Safety devices
Microswitch: it will stop the machine
when the pan lid is opened. When the
lid is closed back, restart the machine
by pressing button I
Safety information
•
It is of the greatest importance to carefully read this manual before carrying out installation and use
operations. Consistent compliance with the instructions contained in this manual will guarantee personal
and machine safety.
•
Do not tamper with the safety devices for any reason.
•
We recommend that industrial safety regulations issued nationally by the appointed organisms be strictly
respected.
•
The manufacturer declines all responsability for injures to persons or damages to property, resulting from
failure to comply with these safety rules.
•
Correct machine setting, lighting and workshop cleanness are pre-conditions for personal safety.
•
Do not expose the machine to atmospheric agents.
•
The machine connection and start-up should only be executed by skilled engineers.
•
Check that the plant mains ratings correspond to the specifications printed on the machine data plate.
•
Make sure that the machine is connected to a grounding system.
•
The work area around the machine should always be kept clean and dry.
•
Wear the work attire prescribed by the industrial accident-prevention regulations.
•
This machine should always be used for its recommended uses ; any other use is deemed improper and
therefore dangerous.
•
Check the suitability and weight of the products to work ; do not overload the machine to exceed its
capacity.
Translation of the original instructions
All manuals and user guides at all-guides.com
C
740 IP10F
1040 IP20F
1240 IP30F
1240 IP40F
1780 IP60F
1780 IP80F
INFORMATION
A B C
mm
480 400 650
560 550 900
650 580 1050
685 620 1050
930 800 1500
950 840 1500
Remote control switch: after an
unscheduled power cut, it requests a
specific machine restart control
Microswitch: it will stop the machine
when the pan is removed from its
location. After the pan has been put
back in place, restart the machine by
pressing button I
1
GENERAL