Hypertherm Powermax45 Conditions De Service page 7

Powermax45
Refer to the following table when connecting the Powermax system to a torch height controller or CNC controller with a
machine interface cable.
Signal Type Notes
Start Input Normally open.
(start 18 VDC open circuit voltage at START terminals.
plasma) Requires dry contact closure to activate.
Transfer Output Normally open. Dry contact closure when the arc
(start transfers.
machine 120 VAC/1 A maximum at the machine interface relay
motion) or switching device (supplied by the customer).
Ground Ground
Voltage Output Powermax45: Divided arc signal of 50:1 (provides a
divider maximum of 7 V)
Powermax65/85: Divided arc signal of 20:1, 21.1:1,
30:1, 40:1, 50:1 (provides a maximum of 18 V).
Field Service Bulletin
All manuals and user guides at all-guides.com
6
3
14
13
Interface cable replacement
5
4
12
Connector
sockets
3, 4
12, 14
13
5 (-), 6 (+)
Powermax65/85
Cable wires
Green, black
Red, black
Black (-), white (+)
5