Milnor Mark II Fonctionnement page 7

All manuals and user guides at all-guides.com
This signal is activated when operator attention is required, as when unloading is required
or certain errors occur. Pressing
This button extinguishes the operator signal (
of a formula, the formula resumes after this button is pressed. If an error caused
illuminate, pressing
illuminated when a valid formula was selected, the signal will terminate automatically
when the formula is started or the door is opened.
Setting the keyswitch to
normal machine operation. Setting the keyswitch to
operation and certain troubleshooting procedures.
This large red button in a yellow rectangle may appear in several locations on the machine.
It performs the same function as
turned to release the button and close the circuit before operation can resume.
This button stops the machine immediately by opening the three-wire circuit. Emergency
Stop buttons perform the same function. Pull cords and kick plates, if the machine has
them, also perform the same function.
This button starts a cycle or resumes an interrupted cycle if a formula is selected and
certain safety considerations are met.
It is also used with other controls listed in this section.
This button retracts the door plunger to unlock the door if the machine is not running.
Pressing jogs the cylinder clockwise or counter-clockwise as set by
This switch determines the direction the cylinder will rotate when jogging is commanded.
Holding the switch at
cancels the signal.
after correcting the error will extinguish the signal. If
prevents programmed data from being changed and allows
, but locks in the depressed position and must be
jogs clockwise; holding the switch at
). If the signal was programmed as part
allows programming machine
jogs counter-clockwise.
to
was
.