Milnor Mark II Fonctionnement page 13

>_b]Q\ ?`UbQdY_^±=Qb[ 99
DY\d Dg_ GQi GQcXUb 5hdbQSd_b
Models 48032BTN, 48036QTN, 52038WTN, 72044WTN—Set the Rear/Front Tilt switch
( ) to Front (
switch ( ) to up (
its rearward limit.
Models 64046E6N, 72046E5N—Simultaneously hold the Start button (
Up/Down Tilt switch (
machine stops at its rearward limit.
NOTE: If a formula was selected before tilting, the drain valve closes and the machine partially
fills. Be sure to close the door before returning to the non-tilted position otherwise the drain will
open and the water will drain out.
41>75B* 5^dQ^W\U Q^T CUfUb 8QjQbTc
2^]cPRc fXcW V^^Sb QTX]V _a^RTbbTS RP] RPdbT cWT V^^Sb c^ faP_ Pa^d]S h^da
Q^Sh ^a [X\Qb P]S SXb\T\QTa h^d
>_T] _^RZTc \PRWX]Tb ^][h°3^ ]^c Y^V cWT Rh[X]STa P]S _d[[ cWT V^^Sb Pc
cWT bP\T cX\T
:TT_ h^dabT[U P]S ^cWTab R[TPa ^U \^eT\T]c PaTPb P]S _PcWb
3^ ]^c ^_TaPcT cWT \PRWX]T fXcW \P[Ud]RcX^]X]V cf^ WP]S \P]dP[ R^]ca^[b
then jog as follows:
Simultaneously hold the Start button (
buttons are released.
Change rotation direction and rotate again, if necessary.
switch to close (
NOTE: Closing the door before tilting down prevents the drain valve from opening and the loss
of water.
Models 48032BTx, 48036QTx, 52038WTx, 72044WTx—Simultaneously hold the Start button
( ) and hold the Up/Down Tilt switch (
its non-tilted position.
Models 64046E6N, 72046E5N—Simultaneously hold the Start button (
Up/Down Tilt switch (
All manuals and user guides at all-guides.com
). Simultaneously hold the Start button (
). Hold until the desired tilt angle is reached or the machine stops at
) to down (
Release the goods from the bag or other loading device,
) and the Jog switch (
Simultaneously hold the Door Open button (
). Continue to hold until the door latches.
) to up (
). Hold until the desired tilt angle is reached or the
or
) to down ( ). Hold until the machine reaches
). Hold until the machine reaches its non-tilted position.
=C?E@>>?15 )$##1F $ '
) and hold the Up/Down Tilt
) and hold the
). The cylinder turns until
) and hold the Hydraulic Door
) and hold the