Black & Decker FSMH1321 Mode D'emploi page 10

ENGLISH
Configuration
12 Floor cleaning
12
head
12a Steam burst floor
cleaning head
12a
12b
12b Carpet glider
13 Floor cleaning
pad
13
16
16 Steam hose
18 Angle brush
18
accessory
18a Angle brush BBQ
18a
accessory
19 Grout brush
19
accessory
20
20 Small squeegee
20a Small squeegee
20a
sock
21
21 Large squeegee
21a Large squeegee
21a
sock
22
22 Steam burst brush
unit
22a 22a Steam burst wire
brush
22b Steam burst brush
22b
22c Steam burst wide
22c brush
23
23 Delta head
23a 23a Flat surface
cleaning pad
23b 23b Garment steaming
interface
23c Garment steaming
23c
brush
23d Garment steaming
23d
pad
23e Delta head carpet
23e
glider
25
25 SteaMitt™
26
26 SteaMitt™ hose
27 27 SteaMitt™ cleaning
pad
27a SteaMitt™cleaning
27a
pad 2
27b SteaMitt™ cleaning
27b
pad 3
28
28 Adjustable nozzle
10
(Original instructions)
All
All
All
All
All
All
All
All
All
All
All
All
All
All
Assembly
Warning! Before attempting any of the following instructions,
make sure that the appliance is switched off and unplugged
and the appliance is cold and does not contain any water.
Attaching the handle (Fig. A)
• Slide the bottom end of the handle (8) into the top end of
the steam mop body (11) until it clicks into place.
Attaching the hand held steam cleaner
(Fig. B)
• Holding the back of the steam mop body (11) push the
hand held steam cleaner (5) firmly into the steam mop
body (11) making sure it sits correctly over the interface
(11a) and clicks securely into place.
Removing the hand held steam cleaner
(Fig. B)
• Push the release button (10) on the main body (11) and
lift the hand held steam cleaner (5) off the interface (11a)
and away from the main body (11).
Attaching a cleaning pad (Fig. C)
Replacement cleaning pads are available from your
BLACK+DECKER dealer :- (cat no. FSMP20-XJ).
• Place a cleaning pad (13) on the floor with the velcro
'loop' side facing up.
• Lightly press the steam mop down onto the cleaning pad
(13).
Note: This unit may be supplied with a standard floor
cleaning head (12) or a steam burst cleaning head (12a). In
either case use these instructions to fit a cleaning pad.
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (8) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
Removing a cleaning pad
Caution! Always wear suitable shoes when changing the
cleaning pad on your steam mop.
Do not wear slippers or open toed footwear.
• Return the handle (8) to the upright position and turn the
steam mop 'OFF'.
• Wait until the steam mop cools down (approximately 5
minutes).
• Lift the steam mop away from the cleaning pad freeing it
from the velcro fastening.
Caution! Never leave the steam mop in one spot on any
surface for any period of time.
Always place the steam mop with the handle (8) supported in
the upright position when stationary and make sure the
steam mop is turned off when not in use.