Torin BIG RED T31002 Guide D'utilisation page 7

ASSEMBLY
1. Attach the casters(No.14) to the Base(No.15) with
bolts, washers, spring washers and nuts;without
tightening the nuts.
2. Slide the caster(No.14) which is connected to the
base(No.15) along with the long holes.
3. Align the caster with the holes on the base, then
attach the casters(No.14) to the base with bolts,
washers, spring washers and nuts. Tighten all
hardware.
4. Connect corresponding (No.14) to the
base(No.15) with bolts, washers, spring washers
and nuts.Tighten all hardware.
5. Slide legs(No.7&8) into front of the base(No.15).
6. Lock legs(No.7&8) in place using the Ring
Pins(No.12),To insert the Ring Pins, lift up front
of Base (No.15) until holes line up. After all four
Ring Pins are inserted, insert one R-Pin (No.11)
through small hole at end of each Ring Pin until
R-Pin snaps into place.
7