Indel B K BASIC Serie Mode D'emploi page 31

SETTING THE TIME
If you press any button from P1 to P4 several times, the display will show the chosen program-
me and then the time.
To set the time, press P2 and P3 at the same time. The hour digits will start to flash and the
display will show the words "set time".
Press - (P2) and + (P3) to set the right time.
To set the minutes, press P1 and then - (P2) and + (P3).
Press P4 to save the new time setting. The display will show
the current time.
To set a programme (P1, P2, P3 or P4) on the Minibar, press
the button of the chosen programme for at least 2 seconds.
If the batteries have run out, the display will show this symbol:
Press ON/OFF to turn the Minibar off. The display will show "Off".
To enable the remote control again, press the ON/OFF key.
ATTENTION!
If the mains power supply is cut off for less than 48 hours, the
Minibar turns on again using the previously set program. If the mains power supply is cut off
for more than 48 hours, the Minibar will be operated by the pre-calibrated thermostat. To set a
program again, follow the instructions given on THE REMOTE CONTROL.
ATTENTION!
If the power supply is voluntarily cut off, wait at least 15 minutes before turning the refrigerator
on again (i.e. before connecting it to mains supply). If not, the compressor could be locked for
few minutes before starting its normal operating.
All manuals and user guides at all-guides.com
SET TIME
TIME
OFF
29