Publicité
OPERATING INSTRUCTIONS
SHELF AND RACK POSITIONS
Depending on the size of your food or the
height of your baking pan, you may wish to
adjust the height and position of the Wire
Rack. There are 2 Shelf Positions that the
Wire Rack or inverted Wire Rack fits into.
Slide the Wire Rack into the Oven making
sure that it is level and properly positioned.
You may use the Wire Rack in the normal
position or invert it.
1. When using the BROIL Function, your food should be 1- 2 inches
from the top element.
2. When baking, the shelf position used will depend on the size of the
food being prepared. It is important to place your food as close to
the center as possible to ensure even cooking.
PREHEAT FUNCTION
Use the PREHEAT Function at 200ºF, for 5 minutes to a maximum time
of 1 hour. The temperature cannot be adjusted.
1. Plug the Digital Convection Oven into a 120V AC outlet.
2. Press the PREHEAT Button. The red Indicator Light next to the
PREHEAT Button will illuminate.
3. The TIME Light will also illuminate and the default TIME 0:30 min-
utes will appear on the Display. To change the TIME, press the UP
or DOWN Arrow and it will change in 5 minute increments. You
may set the Oven to PREHEAT for 5 minutes to a maximum of 1
hour.
NOTE: If you press the SELECT Button, the TEMPERATURE Light will illu-
minate and the preset temperature of 200°F will appear in the Display.
The temperature cannot be adjusted. Press the SELECT Button
again.
4. Open the Door and center food on the Wire Rack. Close the Door.
5. Press the START Button to begin warming. The Display will show the
last selection, TIME or TEMPERATURE. If TEMPERATURE was select-
ed last, it will remain on the Display for approximately 30 seconds;
then it will display the TIME as it counts down. At the end of the
pre-set time, the Oven will sound 5 beeps and turn itself OFF.
(Cont.)
8
Wire Rack
Inverted Wire Rack
Publicité
