V2 AXIL Serie Instructions D'installation page 20

MOUNTING OF THE ACTUATORS
After having set on the pillars the measures chosen from
the table of the previous page, go ahead and proceed
with the following operations:
1. Set and fasten the brackets on the pillars and the
gate.
m
ATTENTION: the front bracket must be
positioned 54 mm lower than the rear bracket.
2. Close the shutter.
3. Unblock the actuators.
4. Take apart the two plastic covers (1 and 2)
5. Position AXIL on the brackets and fasten bolt 3 with
the corresponding self-locking nut and two washers
m
ATTENTION: Insert the two washers as
indicated in panel A.
6. Fasten bolt 4 after having inserted the washer.
m
ATTENTION: verify that it is in draw-bar
bubble as indicated in panel B
7. Try to open and close the shutters manually several
times making sure that there are not frictions between
the actuator and the structure of the gate.
All manuals and user guides at all-guides.com
18