Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
UNPACKING
Carefully lift the monitor out of the packaging and make
sure that all components are included (see Figure 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
CONNECTING
To connect the monitor to your PC ......................
1. Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the monitor and
the PC (see figure 2).
Figure 2. Connecting the monitor to the PC
STARTUP
1. First, turn on your PC, and then turn on your Belinea
monitor. The status indicator (see
should light up green.
2. Adjust the image to meet your requirements (see
the following sections "Image settings using the
OSD menu" and "OSD Menu Functions").
Note: Stabilizer lines
The displayed image contains two very thin, horizontal lines. These lines constitute no defect. They are
stabilizer lines needed for technical reasons.
Figure 1. Monitor with Tilt/Swivel Base
To connect the monitor to the power source .....
1. Connect the separate power cable to the monitor
and a grounded outlet (see figure 3).
Signal cable
3. If there is no image displayed on the monitor, consult
‚
the section "Troubleshooting".
in figure 4)
Figure 3. Connecting the monitor to the power source
Operating Instructions - 13
ENGLISH
Power Cord
Signal Cable
Publicité
