Télécharger Imprimer la page

Makita UC012G Manuel D'instruction page 19

Tronçonneuse sans fil

Publicité

Les langues disponibles

Les langues disponibles

Replacing the sprocket
CAUTION:
A worn sprocket will damage a
new saw chain. Have the sprocket replaced in this
case.
Before fitting a new saw chain, check the condition of
the sprocket.
1
Fig.41
► 1. Sprocket 2. Areas to be worn out
Always fit a new locking ring when replacing the
sprocket.
1
Fig.42
► 1. Locking ring 2. Sprocket
NOTICE:
Make sure that the sprocket is installed
as shown in the figure.
Storing the tool
1.
Clean the tool before storing. Remove any chips
and sawdust from the tool after removing the sprocket
cover.
2.
After cleaning the tool, run it under no load to lubri-
cate the saw chain and guide bar.
3.
Cover the guide bar with the guide bar cover.
4.
Empty the oil tank.
2
2
19 ENGLISH

Publicité

loading