Nakayama PH2570 Mode D'emploi page 9

EN
Gearbox greasing (Fig. 16)
Refill gearbox housing every 25 working hours. Use greese pump. Feed greese until it comes out of the base of blades.
Procedures to be performed after every 100 hours of use
1. Remove the muffler (Fig. 17), insert a screwdriver into the exhaust port and wipe away any carbon deposits. At the same time, wipe away any carbon build-up
on the exhaust port of the muffler and the cylinder exhaust port.
2. Tighten all screws, bolts, and fittings.
3. Check that no oil or grease has penetrated between the clutch lining and drum and, if so, wipe off with oil-free, lead-free gasoline.
Maintenance Chart
System / Components
Fuel leak or spillage
Fuel tank
Air filter
Fuel filter
Idle adjusting screw
Spark plug
Engine
Cylinder fins
Intake air cooling vent
Muffler
Spark arrester
Cylinder exhust port
Throttle lever
Ignition switch
Cutting parts
Trimmer Gear case
Screws/ Nuts/ Bolts
Debris guard
STORAGE
1. Oil the blade to prevent rust.
2. Empty the fuel tank and put the cap back on.
3. Remove the spark plug, pour a small amount of oil into the cylinder.
4. Rotate the crankshaft several times using the starting rope in order to distribute the oil. Put the spark plug back in.
5. Wrap the engine with a plastic sheet.
6. Store the trimmer in a dry place, preferably not in direct contact with the floor and away from heat sources.
DISPOSAL
When disposing your machine, fuel or oil for the machine, be sure to allow your local regulations.
9
Procedure Before use
Wipe clean
✔
Inspect, clean
✔
Adjusting
✔
Clean/ Readjust gap
Clean
Clean
Check operation
✔
Replace if necessary
✔
Grease
Tighten/ Replace
✔
Attach
✔
WWW.NIKOLAOUTOOLS.GR
Every Every Every
25 hours 50 Hours 100 hours
✔
✔
✔
✔
✔
✔
Note
Replace, if necessary
Replace carburetor, if necessary
Gap: 0.65mm
Replace if necessary