Technical specifications
All measurements are with 230V/50Hz mains power
Continuous output power
All channels driven, 20Hz—20kHz, 8Ω
All channels driven, 20Hz—20kHz, 4Ω
One or two channels driven at 1kHz, 8Ω
One or two channels driven at 1kHz, 4Ω
One or two channels driven at 1kHz, 3.2Ω
Peak output current capability
Total harmonic distortion
At any level up to rated power, into 4 or 8Ω
Frequency response
Residual hum and noise
Ref. full power
Voltage gain
Input impedance
Output impedance
Power requirements
Physical
E&OE
CONTINUAL IMPROVEMENT POLICY
Arcam has a policy of continual improvement for its products. This
means that designs and specifications are subject to change without
notice.
NOTE: All specification values are typical unless otherwise stated.
All manuals and user guides at all-guides.com
150W per channel; 1.05kW total
230W per channel; 1.62kW total
160W per channel
250W per channel
300W per channel
±25A per channel
<0.05% (20Hz—20kHz); typically <0.005% at 1kHz
±0.2dB (20Hz—20kHz)
–1dB at 1Hz and 100kHz
–122dB, 20Hz–20kHz, unweighted
x 28.3 (1V input gives 100W/8Ω output)
22kΩ in parallel with 470pF
50mΩ at 20Hz, 1kHz
120mΩ at 20kHz
100, 115V or 230VAC, 50/60Hz, 3kW maximum via heavy duty IEC mains inlet
A soft-start system eliminates large inrush currents at switch on
Dimensions:W430 x D450 x H180 mm
Weight: 31kg (68 lb) nett; 35kg (77 lb) packed
12
RADIO INTERFERENCE
The P7 is an audio device which has been designed to very high
standards of electromagnetic compatibility.
The unit can radiate RF (radio frequency) energy. In some cases this
can cause interference with FM and AM radio reception. If this is the
case, keep the P7 and its connecting cables as far from the tuner and its
aerials as possible. Connecting the P7 and the tuner to different mains
sockets can also help to reduce interference.
EC COUNTRIES –These products have been designed to comply with
directive 89/336/EEC.
USA – These products comply with FCC requirements.