Publicité
Les langues disponibles
Les langues disponibles
Product Overview
7
Digital Display Shows voltage, wattage, status and settings.
A) U-H Output Overvoltage Protection Status
B) U-L Output Undervoltage Protection Status
C) P-H Overload Protection Status
D) Start Up Delay
E) Parameter Setting Codes
Note: The code and value flash alternately every second while changing settings.
14-02-038-933304.indb 3
When output voltage exceeds the preset limit and doesn't return to within
the preset limits after 1 second, your equipment will be disconnected by
the switch. U-H will flash on the display every .5 seconds as long as the
overvoltage condition exists.
When output voltage goes lower than the preset limit and doesn't return to
within the preset limits after 1 second, your equipment will be disconnected
by the switch. U-L will flash on the display every .5 seconds as long as the
undervoltage condition exists.
When the load exceeds the preset range (nominally 110-120%) and lasts
longer than 6 seconds (within this 6 seconds no action will be taken by the
AVS5D), the switch will disconnect from power. P-H will flash on the display
every .5 seconds as long as the overload condition exists.
When the load exceeds the preset range (nominally 150%) and lasts longer
than 1 second, the switch will disconnect from power. P-H will flash on the
display every .5 seconds as long as the overload condition exists.
Overload Faults - You must power cycle the unit to restore the current flow.
The unit does not reset automatically from this type of fault.
When first powered up, the unit will count down a set number of seconds
(default is 6) before monitoring voltage.
E-0 Delay setting
E-1 Undervoltage protection value setting
E-2 Overvoltage protection value setting
E-3 Overload protection value setting
E-4 Displays output voltage or loading power value after startup
(U= voltage, P= watts)
E-5 Restores default settings
3
2/19/2014 2:54:22 PM
Publicité
