Hilti DX 351-BT Notice D'utilisation Originale page 23

Item reference numbers are used in the overview illustration and refer to the numbers used in
the key in the product overview section.
This symbol is intended to draw your special attention to certain points for handling the product.
1.3 Product-dependent symbols
1.3.1 Warning symbols
Warning symbols are warnings of hazards.
Warning: Hot surface
1.3.2 Obligation symbols
Obligation symbols indicate "must do" actions.
Wear eye protection
Wear head protection
Wear ear protection
1.4 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Cartridge fastening tool
Generation
Serial no.
1.5 Declaration of conformity
The manufacturer declares, on his sole responsibility, that the product described here complies with the
applicable legislation and standards. A copy of the declaration of conformity can be found at the end of this
documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
2 Safety
2.1 Safety instructions
Basic safety precautions
WARNING! Read all safety instructions and other instructions. Failure to comply with the safety
instructions and instructions can cause serious injuries.
Keep all safety instructions and instructions for future reference.
▶ Do not tamper with or modify the fastening tool in any way.
▶ Use only fastening tools and items of equipment that are compatible with each other (base plates,
fastener guides, magazines, pistons and accessories) and consumables (fasteners and cartridges).
*377627*
377627
DX 351 BT
DX 351 BTG
01
English 17