ESAB Cutmaster 80 Mode D'emploi page 98

ESAB CUTMASTER 80
5.06 Power Supply Basic Parts
Replacement
WARNING
!
Disconnect primary power to the
system before disassembling the
torch, leads, or power supply.
This section describes procedures for basic parts
replacement. For more detailed parts replacement
procedures, refer to the Power Supply Service Manual.
A. Cover Removal
1. Remove the NOTE screws which secure the
cover to the main assembly. Do not loosen the
lower screws inside the cut out slots in the bottom
of the cover.
Upper
Screws
Slots
Lower
Screws
Art # A-07947
2. Carefully pull the Cover up and away from the
unit.
B. Cover Installation
1. Reconnect the ground wire, if necessary.
2. Place the cover onto the power supply so that
slots in the bottom edges of the cover engage
the lower screws.
3. Tighten lower screws.
4. Reinstall and tighten the upper screws.
5-6
All manuals and user guides at all-guides.com
C. Filter Element Assembly Replacement
The Filter Element Assembly is in the rear panel. For
better system performance, the filter element should be
checked per the Maintenance Schedule (Subsection
5.02), and either cleaned or replaced.
1. Remove power from the power supply; turn OFF
2. Remove the system cover. See "A Cover Re-
3. Locate the internal air line and the fitting from
4. Hold a wrench or similar tool against the locking
Lower
Screws
5. Remove the fitting from the filter element as-
SERVICE
the gas supply and bleed down the system.
moval" in this section.
the filter assembly. Number 1 in the following
illustration.
ring on the filter assembly fitting, then pull on
the hose to release it. (Numbers 2 and 3 in the
following illustration).
2
4
3
sembly by inserting a 6 mm hex wrench into the
internal hex fitting and turning it counter clock-
wise (left). Numbers 4 and 5 in the previous
illustration.
1
Art # A-07989
5
6mm
Manual 0-5396