ESAB Cutmaster 80 Mode D'emploi page 58

ESAB CUTMASTER 80
2.04 Power Supply Specifications
Input Power
Input Power Cable
Input Power Cable
Output Current
Power Supply Gas
Filtering Ability
Ambient Temperature
* NOTE: The duty cycle will be reduced if the primary input power (AC) is low or
NOTE!
IEC Rating is determined as specified by the International Electro-Technical Commission.
These specifications include calculating an output voltage based upon power supply rated
current. To facilitate comparison between power supplies, all manufacturers use this out-
put voltage to determine duty cycle.
Power Supply Dimensions & Weight
10.75"
273 mm
16.375"
416 mm
43 lb / 19.5 kg
2-2
All manuals and user guides at all-guides.com
ESAB Cutmaster 80 Power Supply Specifications
®
400 VAC (360 - 440 VAC), Three Phase, 50/60 Hz
Power Supply includes input power cable.
For cables at other input voltages see section 2.05.
Power Supply includes input cable.
Cable for 400V 3 Phase.
ESAB Cutmaster 80 Power Supply Duty Cycle *
®
Duty Cycle
Current
All Units
DC Voltage
the output voltage (DC) is higher than shown in this chart.
Art # A-07941
22.5"
0.57 m
INTRODUCTION
20 - 80 Amps, Continuously Adjustable
Particulates to 5 Microns
Duty Cycle Ratings @ 40° C (104° F)
Operating Range 0° - 50° C
IEC Rating
40% 60%
80 Amps 65 Amps
112 106
Ventilation Clearance Requirements
24"
610 mm
150 mm
100%
50 Amps
100
Art # A-07925_AB
6"
Manual 0-5396