Before Starting The Equipment - Pattfield Ergo Tools E-ES 430 E Mode D'emploi D'origine

Anleitung_E-ES_430_E_SPK7:_
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Additional handle
Vibration emission value a = 10,462 m/s 2
h
K uncertainty = 1,5 m/s
2
Handle
Vibration emission value a = 6,96 m/s 2
h
K uncertainty = 1,5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
09.12.2010 7:53 Uhr Seite 9

6. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
6.1 Fitting the dust bag (Fig. 2)
Press the pushlock button (9) on the left and right
side of the dust bag (6). Then slip the dust bag (6)
onto the connection for the dust bag (5).
The dust is extracted directly through the
grinding/sanding paper and the grinding/sanding disk
and into the dust bag.
Important.
For health safety reasons it is imperative that you
use a dust bag.
6.2 Fastening the abrasive paper
Easy replacement using Velcro fastening. Ensure
that the extractor holes on the abrasive paper and
grinding/sanding disc line up.
6.3 Adjusting the additional handle (Fig. 3)
Slacken the screw (a) and move the additional
handle (8) to its optimal position.
Lock the additional handle (8) in place by tightening
the screw (a).
7. Starting up
7.1 Switching ON/OFF (Fig. 1)
To switch on:
Press the ON/OFF switch (4)
Continuous operation:
Secure the switch (4) with the locking button (3)
To switch off:
Press the ON/OFF switch (4) briefly
Select the speed by pressing the switch (4) to a
greater or lesser extent.
To pre-select the speed turn the knurled screw (7) of
the switch (4).
The machine can be operated on a temporary or
permanent setting.
GB
9