Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product overview
1
Eye shield (2x)
2
Wheel guard (2x)
3
Grinding wheel coarse-grain
4
Wheel guard securing bolts (6x)
5
Power plug
6
Mounting holes (one at each corner)
7
ON/OFF switch
8
Work rest screws
9
Work rest
10
Grinding wheel fine-grain
INTENDED USE
The tool is intended for dry grinding only.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
BEFORE USE
1
Secure the grinder through the mount-
ing holes
6
screws, nuts or bolts (not included).
3
Mount the mounting brackets to the
grinding wheel guards 2.
86
EN
to a bench with suitable
Using the tool
1. Press switch
7
to ON position (I).
2. Dry grinding: Use the grinding wheel
the grinding wheel 10. Put the work piece
on the work rest
9
and hold it to the rotat-
ing wheel.
3. To switch off the tool, press switch
OFF position (0).
Warning! After switching OFF, the
wheels continue to rotate for some
time.
2
Attach the work rest
Adjust the gap between workpiece
support and grinding wheel
to 2 mm. Ensure that the work rest
is not tilted upwards and tighten the
work rest screws 8.
3
Fit the eye shields
brackets with a gap of 2 mm to the
grinding wheel
3
ing into contact with it.
3
or
7
to
9
with its screws.
3
10
or
9
1
to the mounting
or
10
without com-
Publicité
Chapitres
Table des Matières
