Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Using the tool
Warning! Test the safety switch be-
fore each use. Do not use the tool if
following test fails.
1. Plug into power outlet.
2. Press RESET button 7. The indicator glows
red.
3. Press TEST button 8, the indicator must go
out. Don't use the grinder if this test fails.
4. Press RESET button to use the tool.
5. Press switch
10
to ON position (I).
6. Dry grinding: Use the grinding wheel 14.
Put the work piece on the work rest
hold it to the rotating wheel.
7. Wet grinding: After initially filling the water
bath
4
let the wet grinding wheel
for approx. 1 minute. Check the water level
and refill if required. Put the work piece on
the wet grinder work rest
2
and hold it to
the rotating wheel. After use drain water
bath immediately.
8. To switch off the tool, press switch
OFF position (0).
Warning! After switching OFF, the
wheels continue to rotate for some
time.
140
EN
Care & Maintenance
Caution! Make sure the tool is
switched off and unplugged.
- Wear safety glasses to protect your eyes
whilst cleaning.
- Regular dressing of the grinding wheels will
improve the grinding operation and reduce
vibration. The dressing is done with either
a dressing stick, dressing wheel diamond
dressing tool. All three types of dressing
tools are available in your tool store.
- The grinding wheels should be replaced
12
and
when it's not possible to keep a distance of
2 mm to the work rest or 2 mm to the eye
shield. The wheels and their accessories are
1
rotate
available at any HORNBACH store.
- Contact your local service center, store or
customer service center for any mainte-
nance not referred to in this manual or re-
placements.
- Always give the correct description and
10
to
model number shown on the product label.
- Never immerse the grinder in water.
- Do not use any solvents, as these may dam-
age the plastic parts. Only use a clean cloth
dampened with warm soapy water.
- Wipe metal parts slightly with a light ma-
chine oil to prevent them from rusting.
Caution! If the supply cord is dam-
aged, it must be replaced by the
manufacturer or its service agent or simi-
larly qualified person in order to avoid haz-
ard.
Transport and storage
- Only carry the tool at its casing.
- Secure the tool against shocks and tipping
over during transport.
- Give the grinder a thorough cleaning before
long term storage, including the removal of
all fitted accessories, grinding wheels, eye
shield and tool rest.
- Store the machine and its accessory in a dry
place and out of the reach of children.
Technical Data
Nominal voltage
Rated power
Wet wheel size
Wet wheel no-load speed
Dry wheel size
Dry wheel no-load speed
Sound pressure level (L
)
pA
Maximum wear of wheel allowed:
Wet wheel
Dry wheel
Weight
Protection class
Degree of protection
The values given are valid for a nominal voltage of 230 V. For lower voltage and models for
specific countries, these values may vary.
Please observe the article number on the type plate of the tool.
230 V / ~50 Hz
S1: 150 W / S6 15%: 220 W
200 mm x 40 mm x 20 mm bore
134 min
-1
150 mm x 20 mm x 12.7 mm bore
2950 min
-1
<70dB(A)
150 mm
100 mm
10.2 kg
I
IP23
EN
141
Publicité
Chapitres
Table des Matières
