Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
2
1
2
Product overview
1
Grinding guard
2
Spindle lock button
9
3
Inner flange
4
Outer flange
5
Auxiliary handle
8
7
Intended use
The tool is intended for roughing and grinding
6
of metal and stone materials without the use
of water when equipped with a suitable disc
and the appropriate guard.
5
Using the tool
Caution! Only use grinding wheels
(thickness 6 - 8 mm) for grinding.
4
1. Make sure your workpiece can not slip
3
and hold the tool firmly.
2. To switch on the tool, press the lower
part of the on / off switch
switch forward. Pressing the top part of
the on / off
6
switch locks it in on position.
CHARGE BATTERY
Plug the charger (not included) into a
suitable wall socket.
Caution! Only use the provided bat-
tery adaptor in order to charge the
battery.
6
On / Off switch
7
Battery release switch
8
Soft grip
9
Battery (not included)
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
3. Let the tool run at no-load speed for about
a minute and check if the installed wheel
runs flawlessly. The best grinding re-
sults can be achieved with a 30° to 40°
approach angle. Move the tool back and
forth with moderate pressure.
6
and push the
4. To switch off the tool, release the on / off
switch 6. If the on / off switch
press the lower part of the switch to un-
lock it.
2
Slide the battery
the charger and check its LED:
Red: Charging
Green: Battery is fully charged
Flashing Red: Battery is defective
Flashing Green: Battery is too hot/ cold
6
is locked,
9
(not included) onto
EN
143
Publicité
Chapitres
Table des Matières
