Product Overview; Using The Tool; Intended Use - Pattfield Ergo Tools PE-1200WS Traduction De La Notice Originale

product overview

1
Speed dial
2 Spindle lock button
3 clamping flange
4 Lock nut
5
Auxiliary handle connector
6 carbon brush cap
7 On / Off switch
8 Lock off button
A Grinding guard
B cutting guard

Intended use

The tool is intended for cutting, roughing and
grinding of metal and stone materials without
the use of water when equipped with a suit-
able cutting or grinding disc and the appropri-
ate guard.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
AuXILIAry hAnDLe
1 The auxiliary handle can be attached
to the auxiliary handle
either side of the tool.
caution! Make sure the tool is
switched off and unplugged.
104 EN
All manuals and user guides at all-guides.com
connector 5

using the tool

1. Make sure your workpiece can not slip.
2. To switch on the tool, press and hold the
lock off button
switch 7.
3. Let the tool run at no-load speed for
about a minute and check if the in-
stalled wheel runs flawlessly.
grinding:
The best grinding results can be
achieved with a 30° to 40° ap-
proach angle. Move the tool back and
forth with moderate pressure.
caution! Never use cutting discs for
grinding.
cutting:
When cutting, do not press, tilt or os-
cillate the tool. Gently slide it for-
ward with a speed adapted to the
material being worked on.
The tool must always work opposite to
the direction of rotation, otherwise there
is danger of being pushed out of the
cut in an uncontrolled way.
4. To switch off the tool, release the on / off
switch 7.
2 Screw the auxiliary handle into the
on auxiliary handle connector 5.
For safe working conditions, make
sure the auxiliary handle is always
mounted at the tool.
8 and press the on / off