Cherubini Plug & Play 3000 Instructions page 17

The clamp allows to fix the motor directly on the side-cover bolt
(Ø 12 mm).
The clamp may be used only for motors until maximal torque of
15 Nm.
1
3
The bolt has to be in aluminum with minimal Ø 11,5 and maximal Ø 11,9 mm.
1
The clamp is supplied pre-assembled with the tightening of the screw on right
2
side, in case should be necessary to tighten the screw on the left side go on as
follows:
- remove the screw
- remove the plate
- remove the clamp and reinsert it upside down
- insert the screw from the left side.
Close the screw using an hexagonal key 5 mm.
3
Closing torque minimal 9 Nm maximal 11 Nm, by keeping the motor as near as
possible to the sidecover.
INSTRUCTION FIXING WITH CLAMP
2
17