DeVilbiss Healthcare Drive TOURER PLUS Mode D'emploi page 26

EN
Error code description control unit Rhino 2
If the red LED in the battery display is blinking, the error can be determined using the blink code:
Number of Error
blinks
1 Battery weak
2 Battery voltage is too low
3 Battery voltage is too high Driving is not
4 Time limit for maximum
current limit exceeded or
control unit too hot
5 Brake error
6 Driving is blocked
7 Error of the rotational
speed potentiometer
8 Motor voltage error
9 Other defect
26
Drive Medical GmbH & Co. KG | As per: 02.02.2023 | Errors and alterations excepted
Effect on the Comments
scooter
Scooter slow The charge status of the batteries is low. Charge the
batteries as soon as possible.
Driving is not The charge status of the batteries is empty. Charge
possible the batteries as soon as possible. Check the battery,
connections, and cables.
The charge status of the batteries is too high. Causes
possible can include excessive charging and/or descending a
hill (since in this case the batteries are automatically
charged). When descending a hill, reduce the speed
in order to not charge the battery further. Switch the
scooter off and back on.
Driving is not The scooter has consumed too much current for an
possible overly long period of time, which could be attributed to
an excessive load, jamming, or the throttling of the motor.
Switch the scooter off and wait a few minutes before
switching it on again. The control unit has discovered a
short circuit in the motor. Check the cable harness for
short-circuited electrical circuits and check the motor.
Contact your customer service.
Driving is not Check whether the gearshift lever for the parking brake
possible is in the locked position. The brake coil or the cables
of the parking brake are defective. Check the parking
brake and the cables for short-circuited electrical circuits
or exposed cables. Contact your customer service.
Driving is not A STOP function is enabled or a charge blocking has
possible occurred. Disable the STOP function and separate the
charging unit from the scooter. Bring the control lever
into a neutral position and switch the scooter off and
back on. The control lever may need to be recalibrated.
Check the cables of the control lever.
Driving is not The control lever or its cable is defective. Check
possible exposed cables or short-circuited electrical circuits. The
control lever could be incorrectly adjusted. Contact your
customer service.
Driving is not The motor or its cable is defective. Check exposed
possible cables or short-circuited electrical circuits. Contact your
customer service.
Driving is not The control unit may be internally defective. Check
possible exposed cables or short-circuited electrical circuits.
Contact your customer service.
Instructions for use TOURER PLUS