Set Per-Cup Quantity - NEFF CV 7760 N Mode D'emploi

46 | English
Rinsing the fi lter simultaneously activates
the setting for the Service - change filter
display.
The fi lter is no longer effective when the
Service - change filter
at the latest after two months.
It needs to be replaced for reasons of
hygiene and so that there is no build-up of
limescale (this could damage the appliance).
Replacement fi lters can be obtained
from retailers or customer service (see
"Accessories").
After every fi lter change the fi lter must fi rst
be rinsed. Proceed as described at the
beginning of this section.
If no new fi lter is used, turn the water fi lter
setting to .
Off
You can fi nd detailed information
about the water fi lter in the enclosed
fi lter instructions.
If the appliance has not been used
for a prolonged period (e.g. dur-
ing your vacation) the fi lter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
Further entries in the Settings menu:
: If you want to descale the appli-
Descale
z
ance, press (6) and run the descaling
programme (see "Descaling").
: If you want to clean the
Clean
z
appliance, press (6) and run the clean-
ing programme (see "Cleaning").
: If you want to de s cale and
Calc'n'Clean
clean the appliance at the same time, press
z
(6) and run the Calc'n'Clean pro-
gramme (see "Calc'n'Clean").
: You can cancel your own
Factory settings
settings and reset to the factory settings. To
activate the factory settings, press
Neff
display appears, or
z
(6).
The appliance can also be reset
to the factory settings as follows:
1. S witch the appliance off fully at the
power switch O/I (7).
Y Z
2. P ress (2) and
time, hold them down, and switch the
appliance on again at the power switch
O/I (7).
The factory settings are reactivated.
Set per­cup quantity
The per-cup quantity can be adjusted
individually to suit your cups. It can be set
separately for each type of drink and each
cup size.
1. To call up the default settings, keep i (1)
depressed for at least 3 seconds.
2. Select
Cup volume
navigation button (4).
Z
3. Press (5).
4. Select the type of beverage with the
retractable navigation button (4).
Z
5. Press (5).
6. Select the cup size with the retractable
navigation button (4).
Z
7. Press (5).
8. Adjust the beverage quantity with the
retractable navigation button (4).
Y
(2) returns you to cup size and drink
selection. To quit the default settings, press
i (1). The settings are stored.
Important:
The selected amount in ml is
an approximate value and can
vary signifi cantly as a result of
crema forming, the grind setting
or the type of milk used, etc.
(5) at the same
with the retractable
C77V60N2 | 03/2011