Preparing Milk Froth And Warm Milk; Dispensing Hot Water - NEFF CV 7760 N Mode D'emploi

44 | English
Preparing milk froth and warm
milk
Risk of burns!
The milk frother (19) gets very hot.
After use, allow to cool down first
before touching.
For optimal milk froth, use cold milk
with a fat content of at least 1.5 % if
possible.
1. Take the milk tube (12) and connect it to
the milk frother (19)
(see "Preparation using milk").
2. Place a cup or glass under the outlet of
the milk frother.
3. Select the required setting for
or with the navigation button
Warm milk
(4):
Milk froth
My coffee
z
4. Press (6); milk froth or warm milk
runs out of the milk frother outlet (takes
about 40 or 60 seconds respectively).
z
Press (6) again to cut the process short.
The appliance may make a whis-
tling noise when warm milk is being
prepared. This is caused by the milk
frother (19) for technical reasons
Dried milk residue is difficult to re-
move, so clean the milk frother im-
mediately after use
(see "Cleaning the milk system").
Neff

Dispensing hot water

After use, allow to cool down first before
touching.
The appliance can also be used to dispense
hot water, e.g. for tea.
1. Place a cup or glass under the coffee
outlet.
2. Select
button (4):
Milk froth
3. Press
selection. Set the required temperature
with the navigation button (4):
Warm milk
4. Press
milk frother outlet for about 40 seconds.
z
Press
Risk of burns!
The milk frother (19), from which
the hot water flows, gets very hot.
Hot water with the navigation
Hot water
Warm milk
∼ 85ºC
Z
(5) to switch to the temperature
Hot water
∼ 85ºC
∼ 80ºC
z
(6); hot water runs out of the
(6) again to cut the process short.
Warm up cups before use,
e specially small, thick espresso
cups, with the hot water.
Short rinse
∼ 90ºC
C77V60N2 | 03/2011