Information And Settings; Displaying Information; Displaying Settings - NEFF CV 7760 N Mode D'emploi

Information and settings

Use i (1) to display information (press briefly)
and adjust settings (hold down for at least
three seconds).

Displaying information

In the Info menu (press i (1) briefly) you can
call up the following information:
when it is necessary to descale the
X
appliance
when it is necessary to clean the
X
appliance
when it is necessary to change the filter
X
how much coffee has been dispensed
X
since the appliance was first put into
operation
how many milk drinks have been
X
dispensed
how much hot water has been prepared
X

Displaying settings

Hold down i (1) for at least 3 seconds; the
different setting options are then displayed:
Settings
Language
English
Y Z
Use (2) and (5) to switch between the
different setting options. The currently active
setting is always shown in a larger font. You
can change the setting that is currently dis-
played using the navigation button (4).
To exit the menu, press i (1) again.
The changes you have made
are saved automatically. It is
not necessary to confirm them
additionally.
Neff
The following setting options are
available to you:
Language
to select the display language.
Cup volume
set separately for each type of drink and
each cup size ("Set per-cup quantity" on
page 46).
Water hardness
button (4) to select the required water
hardness (1, 2, 3 or 4) (refer also to "Check-
ing and setting the water hardness").
Coffee temperature
button (4) to set the coffee temperature.
Auto off after
ton (4) to enter the time span after which
the appliance should automatically switch
to "energy saving mode" following the last
drink preparation. A time between 5 minutes
and 8 hours can be set. The default time is
one hour, but this can be shortened to save
energy.
Contrast
from – 4 to + 4 with the navigation button
(4). The default setting is 0.
Illumination
(factory setting) or
On
Water filter
is inserted in the water tank (8), it must be
rinsed:
Cup volume
1. Place the water filter in the water tank
(8) and fill the tank with water up to the
"max" mark.
2. Use the navigation button (4) to select
Press
3. Place a container with a capacity of 0.5
litres under the milk frother (19).
4. Press
through the filter to rinse it and then into
the container.
Empty the container. The appliance is ready
to use once more.
: Press the navigation button (4)
: The per-cup quantity can be
: Press the navigation
: Press the navigation
: Press the navigation but-
: The display contrast can be set
: The lighting can be set to
Off after 5 min
: Each time a new water filter
Y
z
and press (6).
z
(6). Water will now run first
C77V60N2 | 03/2011
English | 45
,
Off
.