Olimpia splendid CALDO TEKNO Mode D'emploi Et D'entretien page 30

High power operation mode (L8)
The appliance heats with a power equal to 2000W (high power).
Low power operation mode (L7)
The appliance heats with a power equal to 1000W (low power).
Ventilation mode (L4)
The appliance heats through operation of the fan only.
When these modes are active it is NOT possible to set the temperature.
3.4.d - Eco mode
In this mode it is possible to set the desired temperature through the keys (A6) and
(A7), the value flashes for a few seconds and, once set, the display (L1) returns to
show the detected ambient temperature.
When this mode is active, the appliance regularly detects the ambient temperature and
automatically selects the best operating mode (high power, low power and ventilation
only) to maintain the set temperature constant.
3.4.e - Silent mode (A5)
Press the key (A4) on the panel or through the remote control to activate this mode.
The appliance reduces the fan speed to make the environment more comfortable.
3.4.f - Anti-frost function
This function activates when the detected ambient temperature is underneath 10 °C,
allowing for correct operation of the thermostat. The Led (L2) lights up.
4 - OVERHEAT PROTECTION
• This heater is protected with overheat protection that switches off the appliance
automatically in case of severe overheating. In this case:
- unplug the appliance;
- wait about 30 minutes for it to cool;
- remove any possible cause of overheating, eg. something covering the heater;
- check for damage to the appliance, the cord and the plug.
• If there is no damage:
- plug the unit back in;
- switch it on as described above.
If the heater still does not turn on, please contact Customer Service for assistance.
5 - SAFETY CONTROL (anti-overturning switch)
• If the appliance falls or overturns, the anti-overturning switch is activated and
automatically turns it off.
EN - 12