Becker U30 Notice De Montage Et D'utilisation page 68

Assembly and Operating Instructions
Notes for professional electricians
Installation and basic settings:
1. Switch off the power supply.
2. Remove the band winder from the band winder case.
3. Set the DIP switches to the desired function.
4. Connect the U30 according to the wiring diagram.
Attention: Currently valid VDE standards must be ob-
5. Install the U30 in the band winder case.
6. Set the selector switch to manual mode (H), i.e. push it to the
right all the way to the stop.
7. Switch on the power supply and press the reset button.
8. Check, if the direction of the motor rotation corresponds with
the direction buttons. If not, exchange terminal 6 with ter minal
7.
68
served when connecting the device, in par ticu lar
DIN VDE 0100/0700 as well as the cur rently valid
regulations of your local power company and
accident prevention regulations.