Publicité
Les langues disponibles
Les langues disponibles
Fitting the door panel
Insert the door panel at an angle towards the back into both
1.
brackets as far as it will go. The smooth surface must face
outwards.
Put the cover back in place and press on it until it clicks in
2.
place.
Refit the appliance door.
3.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side.
Faults and repairs
In the event of a fault, check the tips in the following table
before calling the after-sales service.
Problem
Electrical operation is faulty (e.g. indicator
lamps no longer light up)
Liquid or runny dough runs to one side
Smoke is generated during roasting or
grilling
High levels of condensation are generated
in the cooking compartment
Enamelled accessories have matt, light-
coloured marks
Door panels are misted up
58
Pull the hook-in rack forwards at the rear and unhook to the
2.
side.
Clean the hook-in rack with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the kink (a) facing upwards, so
4.
that the shelf positions match.
Insert the hook-in rack at the rear as far as it will go.
5.
Push the hook-in rack towards the rear.
6.
Insert the hook-in rack at the front as far as it will go.
7.
Push the hook-in rack downwards.
8.
:
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Possible cause
Fuse defective
Appliance not installed level
Fat is burning on the grill element
Wire rack or universal pan inserted incor-
rectly
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Normal occurrence caused by dripping
meat or fruit juices
Normal occurrence caused by tempera-
ture differences
Risk of electric shock!
Remedial action
Check fuses in the fuse box and replace if
necessary
Check the appliance installation (see the
Installation instructions)
Continue grilling or roasting until the fat on
the grill element is burnt away
Check the shelf heights (see section:
Roasting or grilling)
Open the appliance door briefly from time
to time during operation
Not possible
Heat the appliance up to 100 °C and then
switch off again after 5 minutes
Publicité
