Connecting Two Or More Cameras-Multi-Camera System - Sony ExwaveHAD DXC-390 Mode D'emploi

Connecting Two or More Cameras—Multi-Camera System
Notes on multi-camera system
Perform the following to prevent flicker when switching
between two or more cameras connected to a video
switcher:
• Supply the same sync signal to the GENLOCK IN
Sync signal generator
Sync (VBS or
BS) output
VBS OUT
Switcher, etc.
VIDEO IN
Video monitor,
VTR, etc.
75-ohm coaxial cable
DXC-390/390P
VIDEO
VIDEO OUT
DC IN/VBS
OUT
TRIG IN
LENS
MENU LOCK
OFF ON
RGB/SYNC
REMOTE
VIDEO IN
DC IN/VBS
VBS OUT
75-ohm coaxial cable
VIDEO
DXC-390/390P OUT
VIDEO OUT
DC IN/VBS
TRIG IN
LENS
MENU LOCK
OFF ON
RGB/SYNC REMOTE
DC IN/VBS
connectors on each camera adaptor (see below).
• Adjust the subcarrier and horizontal synchronization
phases for all cameras.
For more details, see "Adjusting the Picture Tone in a
Multi-Camera System" on page 41.
Set the MODE selector
1
to the "1" position.
2
GENLOCK IN
CAMERA (12-pin)
CCMC-12P02/05/10/25 cable
Set the MODE selector
1
to the "1" position.
2
GENLOCK IN
CAMERA (12-pin)
CCMC-12P02/05/10/25 cable
Chapter 3 Installation and Connections
CMA-D2/D2MD/
D2CE/D2MDCE
camera adaptor
Power cord
CMA-D2/D2MD/
D2CE/D2MDCE
camera adaptor
Power cord
51
(GB)