Sony ExwaveHAD DXC-390 Mode D'emploi page 44

3ccd
Masquer les pouces Voir aussi pour ExwaveHAD DXC-390:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
Mounting the VCL-614WEA Zoom Lens
Lens control cable
2
2
1
44
(GB)
Chapter 3 Installation and Connections
3
1
1
Remove the mount caps of the camera and lens.
2
Align the threaded portion of the lens mount with that of
the camera mount, and turn the mount lock ring
clockwise as far as it goes to fix the lens to the camera.
3
Connect the lens control cable to the LENS connector
on the camera.
To adjust the position of the lens
After tightening the mount lock ring, loosen it by turning it
counterclockwise by approximately 90º. Then rotate the lens
to adjust the position, and tighten the mount lock ring
securely.
Mounting C-mount lens other than the VCL-
610WEA and VCL-614WEA other
Also refer to the instruction manual supplied with the lens.
1
Remove the mount caps of the camera and lens.
2
Align the threaded portion of the lens mount with that of
the camera mount, and slowly rotate the lens clockwise
to fit to the camera.
To adjust the position of the lens
Refer to the instruction manual supplied with the lens.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Exwavehad dxc-390p

Table des Matières