Publicité
Les langues disponibles
Les langues disponibles
5.6 Vacuum package in a Canister
Wipe canister cover and canister and
ensure they are clean and dry.
Fill the vacuum goods into the container.
Be careful not to fill in too much vacuum
goods.
Connect one end of vacuum hose at the connector at device and other end at connector at
canister cover or with the adapter at canister cover.
Press button for canisters.
To ensure there is no air leaking between the cover and the canister, use your hand to
push down the cover at the beginning of the vacuum operation. The device will stop
automatically when enough vacuum pressure is achieved.
Alternatively you can press button pulse vacuum to adjust the vacuum strength by
yourself and stop at desired point of time.
Remove the vacuum hose from the cover of container first then from the connector at
device. You can cancel the operation at any time by pressing button Vacuum & Seal /
Cancel.
5.7 Storage
Store the device in its upright position, out of the reach of children.
Please note
► Always unplug the appliance from its outlet immediately after using and before cleaning.
► For the correct storage, please slightly close the cover, do not lock, it will deform the
gaskets and affect the machine function.
Cleaning and Maintenance
6
This chapter provides important information on properly cleaning and maintaining your
vacuum sealer.
6.1 Safety information
Attention
Please observe the following safety notices, before cleaning the unit to avoid damage to
the unit or personal injury:
► Unplug the device prior to cleaning it.
► To ensure optimum performance, the unit must be cleaned regularly. Failure to clean
the unit regularly can lead to potential malfunctions, as well as safety and health risks.
► The sealing bar remains hot after use. Wait a few minutes until the strip has cooled
before cleaning.
► Do not use any harsh or abrasive cleaning agents.
15
Publicité
