Télécharger Imprimer la page

WAGNER W 560 Traduction Du Mode D'emploi Original page 31

Masquer les pouces Voir aussi pour W 560:

Publicité

Les langues disponibles

Les langues disponibles

W 560
17. Correction of Malfunctions
Problem
No coating
material
emerges from
the nozzle
Coating
material drips
from the nozzle
Atomisation too
coarse
Spray jet
pulsates
Coating
material causes
"paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
18. Technical Data
Max. viscosity
Power source
Cause
Nozzle clogged
Feed tube clogged
Material volume setting turned
too far to the left (-)
Feed tube loose
No pressure build-up in container
Nozzle loose
Nozzle worn
Nozzle seal is missing or worn
Coating material assembly at air
cap, nozzle or needle
Viscosity of coating material too
high
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
Nozzle contaminated
Air filter heavily soiled
Too little pressure build-up in
container
Coating material in container
running out
Air filter heavily soiled
Nozzle seal is missing or worn
Too much coating material
applied.
Distance to the object too large
Too much coating material
applied
Diaphragm soiled
Diaphragm defective
Technical Data
170 DIN-s
230 V, ~ 50 Hz / 240 V, ~ 50 Hz
Remedy
➞ Clean
➞ Clean
➞ Turn to the right (+)
Insert
➞ Tighten container
➞ Tighten
➞ Change
➞ Insert an intact nozzle seal
➞ Clean
➞ Thin
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean
➞ Change
➞ Tighten container
➞ Refill
➞ Change
➞ Insert an intact nozzle seal
➞ Turn material volume
adjusting screw to the
left (-)
➞ Reduce distance
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean the diaphragm
➞ Replace the diaphragm
GB
25

Publicité

loading