Continental Fireplaces CDVS600N Instructions D'installation Et D'opération page 39

Position the notch located in log #6 against the grate
post.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE FLAME IMPINGEMENT AND
6.5 GLOWING EMBERS
Tear the glowing embers into pieces and place onto the front of the burner. Care should be taken to shred the
embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow when exposed to
direct fl ame; however care should be taken to not block the burner ports. Blocked ports can cause an incorrect
fl ame pattern, carbon deposits and delayed ignition.
6.6 LOGO PLACEMENT
Remove the backing of the logo supplied and centre over the logo installation holes, as indicated.
6
CARBONING.
Place the bottom of log #7 against the right outermost
grate post and the top into the pocket provided on the
center log (#6). Bend up the tab in the log support to
cradle log #7.
39
EN
7
LOGO
W415-0791 / D / 10.21.13