Magmaweld monoTIG 160i Basic Mode D'emploi page 15

monoTIG 160i Basic
2.3 Connections for TIG Welding
2.3.1 Mains Connection
Before plugging your machine to the electrical line, check the line voltage.
• Switch the machine to the position "OFF" "0" and insert the plug
into the socket.
• Switch on the machine via power switch. Observe that the
switch itself and the led displays in the front panel lits, also you
should hear the sound of the cooler fan.
• Secure the gas cylinder to a wall by a chain. To operate safely and
2.3.2 Gas Connections
get best results, use approved regulators.
• Open the gas cylinder valve few times in order to blow out any
possible dirt or particles.
• Connect the gas regulator to the cylinder, make sure that the
threading of the gas outlet of the cylinder and the nut of the
regulator match.
• Screw the TIG torchs ring nut to the TIG welding connector.
2.3.3 Torch Connections
• Connect torch connector to the trigger control connector.
• Insert the earth clamp socket through the Plus signed plug and
2.3.4 Earth Clamp Connection
turn it right tightly.
• To improve the quality of welding procces tie earth clamp as close
as and tightly to the working piece.
www.magmaweld.com
Figure 2 : Gas and Mains Connections
Figure 3 : Gas Cylinder - Regulator - Hose Connections
Figure 4 : TIG Welding Connections
Installation 15
EN
USER MANUAL