Chamberlain Whisper Drive Security+ WD962KCD Manuel D'instructions page 3

Preparing Your Garage Door
Before you begin:
• Disable locks.
• Remove any ropes connected to garage door.
• Complete the following test to make sure your garage
door is balanced and is not sticking or binding:
1. Lift the door about halfway as shown. Release the
door. If balanced, it should stay in place, supported
entirely by its springs.
2. Raise and lower the door to see if there is any
binding or sticking.
If your door binds, sticks, or is out of balance, call a
trained door systems technician.
Sectional Door
Stepladder
One-Piece Door
Carpenter's
Level (optional)
Drill
Sockets and Wrench
1/2", 5/8", 7/16", 9/16"
and 1/4"
To prevent possible SERIOUS INJURY or DEATH:
• ALWAYS call a trained door systems technician if
garage door binds, sticks, or is out of balance. An
unbalanced garage door may NOT reverse when
required.
• NEVER try to loosen, move or adjust garage door,
door springs, cables, pulleys, brackets or their
hardware, ALL of which are under EXTREME tension.
• Disable ALL locks and remove ALL ropes connected
to garage door BEFORE installing and operating
garage door opener to avoid entanglement.
To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and
operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to
avoid malfunction and damage.
Tools needed
During assembly, installation and adjustment of
the opener, instructions will call for hand tools as
illustrated below.
Pencil
Tape Measure
Drill Bits
Wire Cutters
3/16", 5/16"
and 5/32"
3
Hack Saw
Claw Hammer
Screwdriver
Pliers
Adjustable End Wrench