Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Picture U – electrical diagram
1
Motor
2
Motor cord
3
Greed
4
Main switch
4. Preparations
Picture A - Parts
On receipt, carefully unpack the components ensuring that no damage was suffered in transit and that all parts
are accounted for. The following loose items are to be found in the packing case:
A
Table assembly (various models)
B
Arm
C
Manual
D
Bag of loose parts
E
Base
Check the parts against the above list and refer to the pictures. Should there be any deficiencies or damage,
please contact your Huvema dealer immediately.
L
OOSE ITEMS IN BOX AND BAG
Picture B – Loose items
1
Allen key, 3/4/5 mm
2
Worm
3
Chuck (option)
4
Table crank
5
Hex. head screw (4)
6
Support lock handle
5. Assembly
Warning!
For your own safety, never connect plug to power source outlet unti all assembly steps are
completed.
Picture C – Tools needed
1. Screwdriver(s)
2. Combination square
3. Inch adjustable wrench
Combination square must be true. Check its accuracy as illustrated:
2a. Use straight edge of board ¾" thick. This edge must be perfectly straight.
2b. Draw light line on board along this edge.
2c. There should be no gap or overlap when square is flipped over in dotted position.
5.1 Assembly of column and table hardware
Picture D – Column and table support
1. Position base (1) on floor. Remove protective covering and discard.
2. Remove protective sleeve from column tube and discard. Place column assembly on base and align holes
in column support (2) with holes in base.
3. Locate four 10 x 40 mm bolts (3) in loose parts bag.
4. Install a bolt in each hole through column support and base and tighten with adjustable wrench.
7
Pulley cover knob with pan head screw M5
8
Idler pulley
9
V-belt (2x), M24 M26, A27 A29
10
Feed lever
11
Wedge drift
5
Power cord (option)
6
MIcro switch (option)
7
Micro switch for chuck guard assemby
F
Head assembly
G
Box of loose parts
H
Chuck guard assembly (optional)
J
Column assembly
-22-
Publicité
Table des Matières
