Olimpia splendid CALDO RADIALE Mode D'emploi Et D'entretien page 25

• Arrange cord away from traffic areas so that it will not be tripped
over.
2.1 - INSTALLATION OF THE SUPPORT FEET (3b)
It is possible to replace the rubber feet (3a) designed for use on smooth surfaces (desks,
tables, etc.) with the support feet (3b) designed for use on various surfaces such as
mats or floors so as to raise the appliance from the ground by a few centimetres (fig.4).
• Rotate the appliance to be able to access the feet (3) more easily.
• Remove the rubber feet (3a).
• Make the holes of the feet (3) match with the support feet (3b) as shown in figure
4.
• Press until the feet (3b) and (3) match.
3 - USE
Knob "7"
• Knob set to "0" :
appliance OFF
• "VENTILATION" function :
rotate the knob to "
"MINIMUM POWER" function :
•
rotate the knob to "
"MAXIMUM POWER" function :
•
rotate the knob to "
Knob "8" - Thermostat
• Start the appliance by rotating the knob (7) to "
position.
• To set the room temperature to a specific value (thermostatation), rotate the
knob "8" clockwise until it stops.
• Once the desired temperature of the room
has been reached, slowly rotate the knob "8"
anticlockwise until the appliance switches off.
• At this point, the appliance will reactivate
automatically when the room temperature
lowers beyond the set limit and will switch off
again once the room temperature reaches the
set value.
" position.
" position.
" position.
7
" position or to "
8
CALDO RADIALE
"
EN - 9