Operating - Quick HRC 1002 Manuel De L'utilisateur

OPERATING

GB
PERSONALIZING THE CONTROL PANEL
In some HRC models the symbols on the individual keys can be changed by applying the
stickers provided. The procedure for personalizing the control panel is as follows:
• Clean the relevant surfaces with a soft cloth dampened with water (fig. 1).
• Choose a sticker for application to the surface cleaned previously.
• Centre the sticker on the surface without applying pressure and then press it down on the
surface for 5 seconds.
FIG.1
WARNING: the application of adhesives is not recommended if the temperature of the
surface of the control panel is below 10°C.
CONNECTING THE CONTROL PANEL TO THE SOCKET
Connecting the instrument
After installing the socket as described above, proceed as follows:
• Rotate the ring-nut of the protective cover anticlockwise and remove it.
• Insert the instrument plug into the relevant socket, taking care that the position of insertion is
correct.
• Turn the plug locking ring-nut clockwise until fully closed.
Disconnecting the instrument
• Turn the plug locking ring-nut anticlockwise until fully open and remove.
• Cover the socket with the cover provided, turning the ring-nut clockwise.
WARNING: always ensure that the socket is closed with the cover provided when the
instrument is disconnected.
16
5"