Quick HRC 1002 Manuel De L'utilisateur page 14

INSTALLATION
GB
INSTALLING THE SUPPORT
The standard installation procedure is described below. Unfortunately we cannot describe a
procedure applicable to all the situations.
Adapt this procedure to satisfy your own individual requirements.
Find the spot most suitable for the support based on the following criteria:
• The support must be positioned so that it can easily
be reached by the operator.
• Choose a clean, smooth, flat location.
• Check that the back of the panel into which the
screws of the support will be inserted is free from
passing cables, tubes, etc.
• Take particular attention when screwing into the
panels or parts of the boat. The screws must not
weaken or cause the breakage of structural
elements of the boat.
• Place the support onto the chosen surface.
• Fix the support with the 2 screws provided.
INSERTING THE CONTROL PANEL INTO THE SUPPORT
To insert the control panel into the support, follow the instructions in the illustrated sequence:
Insert the control panel slightly rotated into the support and continue the rotation until the
control panel is parallel with the support.
Push the control panel down until it is fully inserted into the support.
14