Toro Titan X4850 Manuel De L'utilisateur page 21

Figure 16
1. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
5. Remove the carriage bolt and locknut on the
side wall of the mower deck securing the left
baffle to the deck (Figure
6. Remove the left baffle from the mower deck
(Figure 16).
7. Locate the 2 bolts in loose parts and use the
existing locknuts and install these fasteners into
the holes shown in Figure 16
to prevent flying debris.
Note:
Install the bolt upward, through the
underside of the deck and use an existing
locknut to secure from the topside.
8. Remove the carriage bolt (5/16 x 3/4 inch) and
locknut (5/16 inch) on the rear wall of the mower
deck securing the baffle to the deck
All manuals and user guides at all-guidesbox.com
g011149
3. Left baffle
4. Install the fasteners here.
16).
on the mower deck
(Figure 17).
1. Locknuts—front of
discharge plate (install
after removing the baffle)
2. Hex-head bolt—forward
hole in deck (install after
removing the baffle)
3. Locknut—forward hole in
deck (install after removing
the baffle)
4. Carriage bolts—front of
discharge plate (install
after removing the baffle)
9. Locate the baffle guard at the front edge of the
side discharge opening
10. Remove the fasteners securing the baffle guard
and the right baffle to the mower deck
17).
Note:
Remove the baffle guard and retain all
fasteners.
11. Remove the 2 locknuts (5/16 inch) securing the
welded posts of the right baffle to the top of
the mower deck at center and right of center
positions (Figure
19
Figure 17
5. Baffle guard—54-inch
decks
6. Locknut (5/16 inch)
7. Carriage bolt (5/16 x 3/4
inch)
(Figure 17).
(Figure
18).
g190737