Publicité
Les langues disponibles
Les langues disponibles
GB
10. Preparation of the Coating Material
Spray material that is at least at room temperature (e.g. diluted with warm
i
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet Download).
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
2. If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until
the feed rate meets your requirements.
11. Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed without
almost any residue.
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.
(Fig. 2 B)
•
Place the container on a paper base and pour in the prepared coating substance with the
aid of the feed hopper included in the scope of supply (Fig. 1, 15). Screw the container
tightly onto the spray gun.
•
Connect the front part with the rear part of the gun (Fig. 3).
•
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
•
Pull the trigger. The W 400 has a two-stage trigger. In the first stage the turbine is started.
If the trigger guard is pressed further, the material is transported.
•
Adjust the spray setting on the spray gun.
22
Thinning recommendation
W 400
dilute by 0-10 %
Publicité
