DeVilbiss Healthcare Drive iGo 2 Mode D'emploi page 2

QUICK START – OPERATING YOUR IGO2 POC
DANGER-NO SMOKING
Read the Important Safeguards and observe all Warnings and Cautions on the product and in the Instruction Guide. Follow all operating instructions. Refer to
Operation section for more details.
IMPORTANT
Before using the device on battery power for the first time, the battery needs to be fully charged. Refer to Initial Battery Charge for details.
1. Install battery. Attach concentrator to
AC or DC power. Battery must be
installed for device to operate.
4. Use "+" or "-" buttons to set your
prescription.
ENGLISH.............................................................................................................................................................................................
ESPAÑOL ............................................................................................................................................................................................
FRANÇAIS ..........................................................................................................................................................................................
EN - 2
2. Connect cannula tubing to oxygen
outlet.
5. To use device in SmartDose mode,
press SmartDose <SD> button.
3. Press and hold Power button to turn
on concentrator.
NOTE– When the iGo2 is turned on, the audible alert activates and the display shows
the hour meter for 3 seconds.
6. Attach standard nasal cannula to
your nose and face. Breathe normally
through the cannula.
WARNING
HOT
This area can emit hot exhaust gas.
Do not place near bare skin.
7. When finished using the device,
press and hold the Power button until
the concentrator turns off.
es-21
A-125B
en-2
fr-42